7010 Single Channel Pressure Calibrator

7010 Pressure Calibrator
  • Range options from 0.2 to 600 bar
  • Accuracy 0.04% of full scale
  • Pneumatic or Hydraulic
  • Over- pressure alarm
  • Piezo - resistive pressure sensor
  • Isolated 24/36V loop supply
  • Loop current measure
  • Mains / Battery Power

 

Description:

Rugged portable pressure calibrators designed for applications from 0.2 bar up to 600 bar in eleven ranges - specify when ordering. For the 7010, the pressure source is via external hand pumps: The 7090 Pneumatic (-950 mbar - 40 bar), or 7095 Hydraulic (0 - 700 bar). Also available a dual channel version (see separate 7015 Dual Channel web page). Alternatively, when external line pressures are available the 7010 can be supplied with an internal regulator to control the output pressure - see separate 7016 LPR web page.

For process signal calibration the loop signal is displayed on the LCD display to 0.05% accuracy. Loop drive supply (24V or 36V) is also provided. Both pressure and loop signal can be displayed at the same time to speed up the calibration of pressure transmitters. Additionally a continuity function is available for testing for open circuit loops.
The 7010 single channel version allows switch selection of five pressure units. These should be specified on ordering from the following:- bar, PSI, kPa, MPa, inWg, cmWg, inHg, mmHg, Kg/cm2, atm.

Both pressure and loop current are displayed on 4.5 digit LCD displays.
RS232 connection for display read-back when used with Time Electronics EasyCal calibration software (option). Straightforward calibration procedures are easy for the user to write within EasyCal. Results from procedures are stored in EasyCal’s results database and printing calibration certificates on demand is simple.
Power is via internal rechargeable cells with a built in mains charger. This allows the unit to be powered directly from the mains if required. The 7010 is housed in a strong resin case that provides on-site protection. All pressure connections are on the side of the case. Leads and an assortment of pressure connection accessories are provided.

For process control signal simulation Time Electronics’ handheld 7006 Loop-Mate is available as an option. It provides 4 - 20mA and 0 - 10V signals at levels of 0%, 10%, 25%, 50%, 75%, 90%, 100%. It can also step through these set points automatically to allow hands free calibration. It is battery powered and can be stored in the 7010’s pouch.

Related Products: 7015 Dual Channel Pressure Calibrator, 7016 LPR Pressure Calibrator, 7018 Differential Pressure Calibrator, 7006 and 7007 LoopMates